Contact us for a quotation! Line 1: 504-362-5183 Llámanos hablamos Español!
Sterling Model SS-40 Dual 15 Pound Accumulator Head Blow Molding Machine
Sterling Model SS-40 Dual 15 Pound Accumulator Head Blow Molding Machine
Serial number- 91080
Head configuration- dual 15 pound heads with 36″ center to center distances between heads
Shot size- 15 pounds per head
Extruder diameter- 4 1/2”
Extruder L:D ratio- 24:1
Extruder horse power- 200
Clamp force- 90 tons
Clear platen dimensions- 72″ width- 44″ height
Machine includes the following:
-Automatic part take out
-Bottom blow stand
Controls- Barber Coleman Maco 6500 controller
Condition- Good- well maintained- can be inspected in operation
Related products
-
Uniloy Model 350 R4 (5) Head Reciprocating Screw Blow Molding Machine
Add to cartUniloy Model 350 R4 (5) Head Reciprocating Screw Blow Molding Machine
Uniloy Model 350 R4 (5) Head Reciprocating Screw Blow Molding Machine (Complete Line)
Serial number- 4085
Machine has side shift capability that enables the
machine to produce off set center neck finishes
Head configuration- 5 heads with 8” center to center
distances between heads
Heads are programmable
Extruder size- 3 1/2 “
Extruder motor horse power- 125
Shot size- nominal 1600 grams
Clamp dimensions- 48” wide x 21 3/4” highMachine has been upgraded as follows:
– Air cooled barrel installed
– G.E. Model AF-300E$ AC variable frequency drive installed
– New Instrucon Model Maco Compact PLC installed
– One new program cylinder installed
– Hydraulic hoses changed
– New open/close valve installed
– All clamp bearings changed
– New PLC installed on Cooling Bed
– New Allen Bradley MicroLogix PLC installed on Trimming Machine
– New Plastech Leak Detector installed on Trimming Machine
– Line includes the following:
– Uniloy Cooling Bed
– Uniloy Model 10042 Trimming Machine
Controls- New Instrucon Model Maco Compact PLC
Condition- Very good- equipment can be inspected dry cycling -
Rocheleau Model RS-25 (8) Head Reciprocating Screw Blow Molding Machine
Add to cartRocheleau Model RS-25 (8) Head Reciprocating Screw Blow Molding Machine
8 Head with 4″ Center to Center Distances
The machine has been well maintained, is in very good condition, is immediately available
-
1999 Cincinnati Milacron Model E-90-Single 5 Pound Accumulator Head Blow Molding Machine
Add to cart1999 Cincinnati Milacron Model E-90-Single 5 Pound Accumulator Head Blow Molding Machine
Well Maintained- Low operating Hours
Can run HDPE, etc. as well as 2 to 6 Gallon Polycarbonate Water Bottles